Aluminum Counter Doors

Specifications Part 1 General
1.01 Summary
A. Counter doors excluding design, construction and preparation of openings; finish or field painting; access panels; electrical wiring, conduit, wire, fuses and disconnect switches Part 2 Products
2.01 Materials
A. Manufacturer: R & S Manufacturing, model S ___
B. Mounting: Face of wall or between-jamb
C. Operation: Push-up is standard (awning crank should be considered when doors are to be operated over a deep counter or over 7' high). Chain hoist or motor operation are optional.
D. Curtain: Interlocking type 15 flat slats are extruded from 6063 alloy aluminum. Endlocks are riveted to slats to maintain curtain alignment. Bottom of curtain is reinforced by an extruded aluminum tubular footpiece with astragal.
E. Guides: Extruded aluminum guides are bolted to aluminum wall angles. Guides are fitted with nylon pile wear strips.
F. Brackets: Steel plate brackets are bolted to wall angles to support curtain and barrel and provide mounting for hood.
G. Barrel: Steel pipe houses torsion spring assembly and supports curtain with a maximum deflection of .03 inch per foot of width. Torsion springs are mounted on a continuous cold rolled steel shaft, adjustable by a tension wheel outside or inside one bracket.
H. Hood: Formed from aluminum sheet, reinforced with top and bottom flanges to limit deflection.
I. Locking: Slidebolt locks (cylinder locks are optional). 2.02 Finish
A. Aluminum slats, footpiece, guides and hood are clear anodized. Steel brackets receive one coat or rust inhibiting grey primer. (Dark bronze and other color anodized finishes are optional.) Part 3 Execution
3.01 Installation
A. Counter doors are to be installed by an R & S authorized representative in accordance with R & S installation instructions.

Cylinder Locks: on footpiece or guide
Finish: standard clear anodized finish may be upgraded to mill or bronze
Powdercoat Finish: on curtain, footpiece, and guides
Tubular Motor Operator: motors completely contained within the barrel can be provided for counter doors up to 84 square feet in limited usage applications. Only the manual crank override is visible outside the bracket. The units are available in 115 volt/single phase with constant contact one button or keyswitch control. They can also be provided with a low voltage controller when options such as a reversing edge or timer are required.

Counter Doors

Specifications
Options
Model Designations
Guide & Footpiece Details
Clearance Requirements
Slat Detail

top

Aluminum Counter Door Options

Aluminum Counter Door Model Designations

top

Aluminum Counter Door Guide & Footpiece Details

top

Aluminum Counter Door Clearance Requirements